Agents
The Agents card counts installs. One install is one agent on one endpoint. Each install has one of three states:
Confirm current coverage by finding a new tool call in Explore. Blocking also requires an enforced policy that covers the agent and endpoint.
Home counts Claude Cowork as Unmanaged when it runs in Anthropic’s cloud. Kontext cannot observe those sessions yet.
Select an agent to see the endpoints it runs on, or a state to filter the endpoints table.
When Home lists only some endpoints, the card counts the most recently active endpoints and states this limit.
Elevated access
The Elevated access card counts endpoints where an agent has any of the following:
Select a fact to filter the endpoints table.
Resources
The Resources card lists MCP servers, plugins, connectors and stored credentials your agents can reach. Select All resources for the full list, or a resource to open its drawer. The drawer lists who can reach the resource, by person or endpoint. Ways in lists each route. Kontext marks routes from agent settings as Configured. It marks routes from recorded sessions as Seen in use. What a policy can do explains how a policy can cover the resource. Select New policy to open Policies. Kontext finds resources through its resource scan. You can disable the scan under Settings → Data Collection. See data collection.Endpoints
The endpoints table lists each endpoint’s agents and the resources they can reach. Search by name, or filter by Status, Installs or Reaches. The dashboard shows Active if the endpoint checked in within the last 15 minutes. It shows Stale after that, or Never seen before the first check-in. The dashboard counts endpoints on older CLI versions below the table. Use the toggle to show them. Select an endpoint to open its drawer. The dashboard shows the person’s email, Kontext version, and last check-in above these details:- In a self-serve workspace, the Person section says when an endpoint connected with a workspace API key and has no person attached. Run a fresh Get started setup command on the endpoint to attach a person.
- How to fix it appears when an agent’s hooks are missing and gives the command or package step that restores them.
- The agent list shows the agents Kontext found on the endpoint and each agent’s last use.
- The drawer reports Claude Code and Codex hooks as Installed or Missing. It shows Not detected if it cannot find the agent, or Not reported if the CLI cannot report hook status because it is too old.
- Use Guardrail LLM to turn the endpoint’s local guardrail model on or off. See detection.
- Version shows the endpoint’s Kontext version.